STEP 1: Set up the wardrobe skeleton. The following numbers are the different parts of the skeleton.

STEP 2: Connect Bars for the top and bottom to its base.

STEP 3: The base with three bars should be on the top of the hanging rail.

STEP 4: Connect bars for the side panel.

STEP 5: This is the actual setup. Measure the width x length of the wardrobe for your divider.

STEP 7: Put marks on each corner.

STEP 8: Make a hole in the marked corners.

STEP 9: Shoot the holes in each corner of the sidebars.

STEP 10: Now you will see the garter stretched out and fitted into the wardrobe's actual size.

STEP 11: Add more garters horizontally and vertically to support the clothes you will put on.

STEP 12: Sew each pinned elastic band.

STEP 13: Remove the excess garter.

STEP 14: Add another elastic band, shoot it in the sidebars, and sew it together.

STEP 15: Put rubber bands under your divider so it does not slide down when you put your clothes.

STEP 17: Slide down the divider until you reach the rubber band locks.

STEP 18: Finish it by putting the cover.